Hi
This may be of interest
http://www.dxing.info/equipment/rolling_your_own_bryant.dx
73
Tony VK2IC
On Fri, Mar 14, 2014 at 12:13 PM, Gary K9GS <garyk9gs@wi.rr.com> wrote:
> Can anyone point me to a design for a splitter for sharing a Beverage
> antenna between two receivers? This is for Field Day so these are not
> optimized Beverages by any means.
>
> Just want to allow the 80/40M stations to share antennas. Nothing fancy.
>
> My thoughts are to just use a CATV "2-Way" splitter at the output of the
> Beverage matching transformer and run separate feed-lines to each radio.
> I'm pretty sure these things work down to 1 MHz but have not measured them.
> I can use the pre-amp in the radio (K3) to compensate for the loss.
>
> Thoughts?
>
> --
>
>
> 73,
>
> Gary K9GS
>
> Greater Milwaukee DX Association: http://www.gmdxa.org
> Society of Midwest Contesters: http://www.w9smc.com
> CW Ops #1032 http://www.cwops.org
>
> ************************************************
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|