I am using 2xTS590 and never had any issues either.
73s Filipe
CT1ILT CR6K
Sent from my Huawei Mate 8
Em 24/03/2016 12:05 p.m., "Terry Posey" <tposey@nettally.com> escreveu:
> Hi Mark -
>
> I have not experienced K3 TX/RX antenna isolation problems with my station
> configuration. I expect that if there is an isolation problem with your
> rig's TX and external RX antenna routing/switching, that problem would be
> nearly impossible to quantify using your station's TX and RX antennas. The
> rig's TX/RX isolation would need to be measured on the bench, using good
> laboratory grade equipment.
>
> Perhaps, Elecraft can provide a list of expected isolation values that were
> measured for each of the TX and external RX antenna routing/switching
> configurations possible with the K3 and K3S. Those measurements would
> surely have been done during the rigs' design performance verification
> tests.
>
> GL
>
> 73,
> Terry K4RX
>
> ++++++++++++++
> Hi Bill,
>
> I think this is not what I meant here; I also do use BPF's and the Front
> End
> Savers.
>
> The problem is that while listening to your receiving antennas, there is
> also some signal from the transmit antenna getting through thanks to the
> internal cross-talk of your rig's TX/RX relay.
>
> I was wondering what people do besides the obvious 'kill the TX antenna
> input during RX mode' ?
>
> 73 Mark, PA5MW
>
> _________________
> Topband Reflector Archives - http://www.contesting.com/_topband
>
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|