TenTec
[Top] [All Lists]

Re: [TenTec] Orion 2 output power

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Orion 2 output power
From: shristov <shristov@ptt.rs>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 07 Feb 2010 22:48:11 +0100
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>

Adjust the ALC SET pot (R179) on the A5 IF Board, beneath the speaker.


73,

Sinisa  YT1NT, VE3EA



----- Originalna poruka -----
Pošiljalac: Steve Narducci <steve@ndwave.com>
Datum: Nedelja, Februar 7, 2010 22:07
Tema: [TenTec] Orion 2 output power
Primalac: 'Discussion of Ten-Tec Equipment' <tentec@contesting.com>

> 
> I picked up a second hand Orion 2 six months ago.
> The output power is off on its reading as I am sure the previous owner
> played with this.
> While reading 65 watts it really puts out 100W.
> It will go way above 100W if I run her up.
> However, I really want to bring it back into specs.
> Anyone have a how-to guide on doing that?
> 
> Thanks in advanced!
> 
> Steve W9SN
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>