TenTec
[Top] [All Lists]

[TenTec] The OCFD Mystique

To: tentec@contesting.com
Subject: [TenTec] The OCFD Mystique
From: "Barry LaZar" <k3ndm@comcast.net>
Reply-to: Barry LaZar <k3ndm@comcast.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 22 Sep 2015 17:35:07 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Fellas,
There is nothing magic about an OCFD. It just a variant of the Windom that was invented, I believe, in the 1920's. It's nothing more than a dipole fed off center so that when you use it on even multiples of a 1/2 wave the impedance is either 50 Ohms or in the region of what your tuner can handle. If you can get it up 35 or more feet, it does make for a pretty good all around antenna. I have a variant called a Carolina Windom. It's up about 40 feet and I've worked DXCC, mixed CW, and phone. I've also gotten my WAS using it and 100 Watts.

The issue of SWR is a red herring. So long as you can tune the "system" such that your rig can accept what the tuner gives it, that is really all that matters. Yes, there are losses associated with high SWR, but if you use low loss transmission line, the additional loss due to high SWR can be pretty trivial, a 1db or so, depending on SWR and band being worked. On 10 meters my system losses total around 2 db which includes everything behind the tuner.

One thing that must be remembered is that the transmission line from the antenna to the station can be an impedance transformer if the SWR is greater than 1:1. What this means is that what you measure at the station may not be reflective of what the antenna is reflecting. So, some of the comments about this antenna works well over all but this band or another may not be accurate unless the effects of the length of the transmission line is included.


Bottom line from here is put up 66' or 132' of wire. Feed it ~ 1/3 of the way from an end. Use a 4:1 current balun if you don't want the feed line to radiate or voltage balun if you do. And, if you force the feed line to radiate, put a good RF choke about 15 or so feet down from the antenna feed point point, load it up, and start working the world. Just remember to use a good low loss coax like Belden 9913 or Times Wire LMR-400.


73,
Barry
K3NDM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>