Re: [TenTec] Aragonaut 509 - multipler tuning (resolution)

[w0ep <w0ep@w0ep.us>]

I received some help from off-list emails.

Here is what I did:

I set the bandswitch to 10 meters and the tuning to the low end of the dial.
Using an external receiver, I found the oscillator signal at 19 MHz
and tuned the T1/T2 slugs for maximum output.

I followed the rest of the instructions in the same way, retuning the 
external
receiver as necessary.

Thanks for your help!

Chris
w0ep




On 2/5/19 1:09 PM, w0ep wrote:
> I'm working on the alignment of an Aragonaut 509.
>
> I'm looking at the manual, page 3-10 which talks about
> the 80233 Oscillator board.
>
> The section labeled "Multipler Tuning", I am having a hard time
> trying to understand the measurement to be made.
>
>
> Here is the instruction:
>
> "Set the oscillator to 10 meters and the frequency to 6333 kHz.
> Peak both the bottom and top slugs in T1 for 19 MHz."
>
>
> Where do I measure, or insert, the "injection frequency" of 19 MHz?
>
>
> Chris
> w0ep
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec