I had that display problem with my Corsair. There is some switching
logic on the frequency display board that comes into play when
switching bands or modes. I found a shorted ceramic bypass capacitor
that was fouling up the logic.
73,
Bob WB2VUF
On 6/12/2016 2:02 PM, W8BVH wrote:
I had similar problem and found a couple of xtals were missing.
Replaced the missing xtals and still had problems on 10 meters . I
found that reseating the xtal w/ some deoxit took care of the problem.
I agree if the jumper on the back is missing it is probably the problem.
Ralph Howes
W8BVH
----- Original Message ----- From: "Tom Cooper via TenTec"
<tentec@contesting.com>
To: <TenTec@contesting.com>
Cc: "Tom Cooper" <w1eat@yahoo.com>
Sent: Sunday, June 12, 2016 12:42 PM
Subject: Re: [TenTec] Omni D help needed
On the back of the older Omni radio there was a jumper used when no
external VFO was attached. If That jumper is missing you will have
the symptoms you describe.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|