Toby,
I did not take time to record any of the ORION audio while I had it, but
I've checked the O2 audio as a result of the negative comments about it and
have not found it to be lacking... Recording it, or monitoring through
another receiver or on the air reports are all no problem.
MIC 52
SP 3
Power 100 watts
microphone is a Ten Tec 706. I do not have any RF feed back at my station
that is noticable. So I think analytical discussion here will require a
controlled test of the audio between the rigs. Or you can say the O2 soulds
bad and I can say the O2 sounds good...
Ron
KA7U
-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Martin, AA6E
Sent: Wednesday, April 05, 2006 9:03 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] The Bug
I don't have an opinion about O2 sound vs O1 (V1) or O1 (V2), but I would
like to see measurements instead of comments like "not robust". I haven't
got a clue what robust sound is!
73 Martin AA6E
On 4/5/06, Toby Pennington <toby423@earthlink.net> wrote:
>
>
> I haven't heard a really good sounding O2 yet. OK, Yes, but not like the
> robust audio coming out of the V1 firmware on the Classic Orion. Toby
> W4CAK
>
>
--
martin.ewing@gmail.com - AA6E@arrl.net
President, Yale University Amateur Radio Club - W1YU
http://blog.aa6e.net
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|