What radio have you chosen for CAT? I am using the IC-735 and the use of
the ALIGN macro works FB in my setup... I have an 'align' macro that
switches in the 500 Hz RTTY filter and then moves the signal to the middle
of the passband.
How are you triggering transmit? Do you have a special cable that separates
out DTR/RTS or are you using the OnTX and OnRX macros to send the correct
Omni VI commands?
- jgc
John Clifford KD7KGX
Heathkit HW-9 WARC/HFT-9/HM-9
Elecraft K2 #1678 /KSB2/KIO2/KBT2/KAT2/KNB2/KAF2/KPA100
Ten-Tec Omni VI/Opt1
Alinco DR-605TQ
Icom T90A
email: kd7kgx@arrl.net
> -----Original Message-----
> From: tentec-bounces@contesting.com
> [mailto:tentec-bounces@contesting.com]On Behalf Of Mark Erbaugh
> Sent: Wednesday, September 24, 2003 8:30 PM
> To: tentec@contesting.com
> Subject: [TenTec] MixW & Omni VI
>
>
> I'm trying to set up MixW for the weekend's RTTY contest. There
> is a macro,
> ALIGN. I assume that the function of the macro is to move the selected
> signal to the desired audio frequency.
>
> I tried entering the macro <ALIGN:750>
>
> When I execute it, the position of the receive marker on the
> waterfall goes
> to 750 Hz, but the radio does not retune to bring the received
> signal to 750
> Hz. In fact, the radio doesn't change frequency at all. However, if I use
> the CAT bar or other means of changing the frequency from within MixW, the
> Omni does change frequency so I think the program is communicating.
>
> Any ideas? or have a I misunderstood the purpose of the ALIGN macro?
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|