jim,
pop the covers
remove and then plug back in connectors 82 and 83 on the 81595 board (mixer)
remove and then plug back in connector 82 on the logic board
with your vom measure voltage on connector 82 on the 81595 mixer and connector
82 on the logic board.
I can’t tell you what pin, but a guess at looking at the schematic on connector
82 on the logic board the 160 meter band is the pin closest to the left of the
connector as you look down with the tab on the rear.
as you step through the bands, you’ll see a pin go high. change bands and that
pin will go low and the next one high.
Mike Bryce wb8vge
prosolar@sssnet.com
On Aug 18, 2014, at 12:13 PM, Jim Allen <jim.allen@longhornband.net> wrote:
> "As I advance the PWR control, and get on the other side of halfway, there
> are occasional spikes on the meter, very short. As the PWR is advanced,
> the Ic suddenly jumps from zero to about 10, then increases erratically up
> to near 20, with no output on the wattmeter."
>
> 73 de W6OGC Jim Allen
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|