Have you tried a wooden stick to poke around on the boards?
Heat from hair dryer?
Cold from a spray can ?
I think TenTec press fits wires into there plugs and they may be needing a
re-seat too?
Could be a cracked trace, but more likely a bad solder joint that looks just
fine.
Walt K8CV Royal Oak, MI.
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, September 03, 2008 12:15 AM
Subject: Re: [TenTec] OMNI V Problem Growing...
> No problem with that Joe.
> This is a brain buster.
> Can't get it to stay dead to trace it.
> Dan/N4VET
>
>
>
> **************It's only a deal if it's where you want to go. Find your
> travel
> deal here.
> (http://information.travel.aol.com/deals?ncid=aoltrv00050000000047)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|