Remove the covers. Loosen the top screws to the upper left and right sides
to allow the front panel to tilt forward. Un plug all the ribbon cables,
one at a time, and re plug them. I recall that the display board and
display processor are mated with a sandwich connector. Work these apart and
re-assemble. Put it all back together and likely the problem will be
solved.
73
Bob, K4TAX
----- Original Message -----
From: "John King" <k5pgw@yahoo.com>
To: <tentec@contesting.com>
Sent: Wednesday, November 06, 2013 4:23 PM
Subject: [TenTec] Omni VI + KC digit
I have a wonderful Omni VI+ transceiver, which I have used for many years,
that functions beautifully EXCEPT for one digit in the digital readout that
doesn't read. That is the kilocycle digit that doesn't read and shows
nothing in the kilocycle range.
In other words, 3.925.00 reads 3.92-.00. The readout does not display the
kilocycles for us OLD geizers or kilohertz for the baby boomers and newer
Ten Tec fans.
Has anyone experienced intermittent digit readout such as that described
above? If so, what did you find wrong and how did you cure the problem?
Your input will be appreciated based upon your Ten Tec knowledge and
experience.And YES it is plugged in. 73, John, K5PGW
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|