That is it, thanks. I remember now that was an added feature sometime after
the manual was released.
On Oct 23, 2010, at 10:52 AM, John Frazier wrote:
> You are correct Carl.....
>
> John W4II
> ----- Original Message -----
> From: "N4PY2" <n4py2@earthlink.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Saturday, October 23, 2010 12:19 PM
> Subject: Re: [TenTec] Orion I Display Question
>
>
>> I think that may mean band register "c". Try pressing a band button
>> multiple times and see if it changes.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Drive
>> Hays, NC 28635
>> www.n4py.com
>>
>>
>> ----- Original Message -----
>> From: "AL7CR" <al7cr@punakea.com>
>> To: "Equipment Discussion of Ten-Tec" <tentec@contesting.com>
>> Sent: Saturday, October 23, 2010 1:09 PM
>> Subject: [TenTec] Orion I Display Question
>>
>>
>>> I am running version 2.063Xg software. On the A VFO display just above
>>> the
>>> hundred hertz value a lower case "c" is displayed. I can't find the
>>> meaning of that in the manual. Can someone help me out? If it IS in the
>>> manual a reference to the page and section would be helpful.
>>>
>>> Thanks,
>>>
>>> AL7CR
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|