Barry
I fiddled with this on a Corsair II. The offset for it was 750 Hz for cw
but on the O6 it would depend on your sidetone frequency setting. I would
guess 1500 Hz for SSB +/-. I lost interest because it tuned backwards.
IOW.... tuning up the band caused the signals to move down. It's an (IF)
thing:*)
I would think OmniRig would be needed to interface the rig to SDR-C but I
used HDSDR. It can operate OmniRig which in turn operates most any rig via
serial port.
Let us know how it goes.
Steve N4LQ
On Sat, Dec 24, 2016 at 1:48 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> Can anybody please provide the correct freq settings to use with panadapter
> software being driven off the 9MHz i.f. output:
>
> IF OUTPUT 9.???.??? MHz
> Offsets CW ??? Hz
> LSB ??? Hz
> USB ??? Hz
>
> FWIW, I'm driving an SDRPlay RSP1 off my Omni 6+ 9MHz i.f. through a
> Clifton Labs Z10000B buffer amp. I'm using SDR Console v3 software. This
> looks like it's going to be a very cool setup. I am fully documenting the
> install.
>
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|