"k e y"
73, Barry N1EU
On Wed, Oct 2, 2013 at 11:18 AM, JOHN <ku3g@yahoo.com> wrote:
> Thanks , I just don't remember using anything else but the serial port for
> the logging
> 73 john
> ps where does that get connected in the rear of the omni
>
>
> ________________________________
> From: Barry N1EU <barry.n1eu@gmail.com>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Wednesday, October 2, 2013 6:05 AM
> Subject: Re: [TenTec] omni 6
>
>
> You need a keying interface between the computer and Omni that will
> drive the key input of the Omni. This is typically done with a COM
> (or LPT) device or a WinKey keyer.
>
> 73, Barry N1EU
>
> On Wed, Oct 2, 2013 at 9:58 AM, JOHN <ku3g@yahoo.com> wrote:
>> Good . morning ,just got a used Omni 6 and am running n3fjp software.After
>> some intial problems the logging and spotting work great but I am having
>> some difficulty setting up the keying using the external keyboard and the
>> computer. I had an Omni before and recall or I think I do that there was no
>> other connection from the computer
>> to the rig , any help would be appreciated
>> 73
>> John KU3G
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|