Thanks for the tips - I'll add them to the TenTec Wiki. In my case, I'm
looking for the knobs for purely cosmetic reasons.
73, Barry N1EU
On Wed, Nov 16, 2016 at 10:18 PM, James Boswell <jboswell@nrao.edu> wrote:
> On 11/16/2016 12:09 PM, Barry N1EU wrote:
>
>> I'm looking for Bandswitch and Drive knobs in good shape if anybody has
>> spares out there?
>>
>> Thanks & 73,
>> Barry N1EU
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>> Barry,
> I know about the knob problem on CorsairII. In the past I have
> repaired these knobs. First you remove the set-screw from the knob. Next
> you use silicon to fill the area where the setscrew travels through the
> knob. The inter collar breaks where the switch shaft contacts the knob. I
> take a pare of needle nose pliers and reform this collar as best as I can.
> I use superglue on the cracked plastic. After the superglue has set I use
> JB Weld to back fill the space between the inside collar and the outside
> skirt of the knob. Now you remove the silicon that protected the setscrew
> area of the knob. Knobs repaired this way have worked for many years. I
> hope this helps,
>
> Take Care, 73'S KA5SIW
>
>
>
> > James B. Boswell JBoswell@NRAO.edu
> > VLA Engineering Services Office: 575 835-7427
> > National Radio Astronomy Observatory C.Phone 505 412-3732
> > Post Office Box 0
> > 1003 Lopezville Road
> > Socorro, New Mexico 87801
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|