To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
---|---|
Subject: | [TenTec] PTO rebuild question |
From: | Barry N1EU <barry.n1eu@gmail.com> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Wed, 17 Apr 2013 22:25:46 +0000 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Can somebody suggest a good method to remove the bearings from the tuning shaft? One fell right out but the other two seem stuck. Thanks & 73, Barry N1EU _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] Tuning Amp on 17 meters, Jim Brown |
---|---|
Next by Date: | Re: [TenTec] PTO rebuild question, Barry N1EU |
Previous by Thread: | [TenTec] Tuning Amp on 17 meters, Richards |
Next by Thread: | Re: [TenTec] PTO rebuild question, Barry N1EU |
Indexes: | [Date] [Thread] [Top] [All Lists] |