Scott, I believe there is an internal pot which balances the RIT pot on the
front panel. It sounds like it is not set correctly. Hope that's your
trouble for it's an easy fix.
73, Mike N4NT
----- Original Message -----
From: <scottsheppard@videotron.ca>
To: <tentec@contesting.com>
Sent: Sunday, November 20, 2011 9:13 PM
Subject: [TenTec] help with Corsair II tx/rx off freq issues
>I just recently picked up a lovely Corsair II (to add to the TT madness)
>and the DDS kit from N4YG,,,the difference, by the way, is amazing and
>makes the rig an even greater pleasure to use than before.
>
> Upon installing it and actually using the rig a bit, however, I note that
> my Tx and Rx freq are not aligned. Its not that the rig display may be a
> bit off but rather the station signal I am listening to is on one freq and
> when I transmit back, I am about 600hz off (as though working split--which
> I am not), I did not adjust anything else after the install but the issue
> may have been pre-existing.
>
> Seems to me I had similar issues on an older Omni A but don't recall what
> I tweeked or balanced...any thoughts from the Corsair crowd?
>
> 73
>
> scott va3ied
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|