Check pictures 2,3,4,5,and 7 at
https://www.flickr.com/photos/pa5mw/sets/72157640001358005/
There was no cutting done on the cabinet
I used short pieces of 1mm copper wire, soldered in the power poles
The Anderson Power Poles were seated against the pcb, and the extruding
copper wire soldered to the large 5KP15A diode,see picture 3.
The copper wire from the Postive Anderson Pole is bended 90 deg and flat
soldeered to the pcb track, see picture 5
I cannot show any other pics as we are awaiting the ORION to return from
last year's IG9Y CQWW SSB event.
73 Mark, PA5MW
-----Original Message-----
From: denton sprague
Sent: Sunday, March 22, 2015 10:35 PM
To: Discussion of Ten-Tec Equipment
Subject: [TenTec] Orion power connector mod
Got a used TT Orion comming…there used to me a place that had all the mods
to this fb rig.
I am looking for the site that has instruction on how to convert the dc
power plug to anderson power poles.
Anyone give me a link? thanks de WB7TDG
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|