You may not have to put the lid on the ceramic crock.
Jim de wd4air
>From: Randy Russe3ll <lord_russell53@yahoo.com>
>Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>Subject: Re: [TenTec] If you ground it - it will come!
>Date: Fri, 5 May 2006 12:46:33 -0700 (PDT)
>
>When the Ham community and Electronics Industry agrees
>on what constitutes a proper ground, would someone
>please let me know. I have spent some serious hours
>reading every possible thing I can, so as to determine
>what is the final say on The Matter. All this just to
>do the proper job, right, the first time, and know I'm
>covered. I give up. I've bonded all my equipment
>together by 1 ft.x1" braided straps to a 8 ft. long
>strip of copper 12" in wide. It runs along my back
>table top then directly out (thru the door jamb)and
>straight to a gnd rod outside 6" from the from the
>edge of the door frame. That ground rod connects with
>two others by #6 gauge wire, and the water pipes and
>tv cables, telephone lines, are bonded to this also.
>That's as good as it's going to get. In unsettled or
>stormy weather, or when not in use for any period, I
>pull the AC plugs and disconnect antennas. I drop the
>coax connector ends into a big ceramic crock, and put
>the lid on. That's just going to have to do.
>
>--- Lynn Lamb <w4nl@charter.net> wrote:
>
> > Grounding/Ungrounding....
> >
> > Suggestion: Disconnect/unplug everything often and
> > pull to the center of the
> > room!
> >
> > Everything means: rotator controls (A/C and control
> > cables), remote switches
> > (again A/C and control cables), modems, phone lines
> > (Oh gosh, for sure),
> > Printers (etc), BEVERAGES, keyers, and ALL GROUNDS
> > for sure.
> >
> > It's not that lightning or static charges will 'get
> > your equipment'; it's
> > 'when it will get your equipment'.
> >
> > Bond equipment together is fine and recommended, but
> > NOT to a ground rod
> > (s). I know little about life perhaps, but
> > suggesting any ground path
> > directly or remotely through equipment is just
> > asking for problems.
> >
> > We all need to know more about RF grounding and A/C
> > grounding, hi.
> >
> > Now the flames.. they are authorized, but this bloat
> > is following his own
> > advice, perhaps a bit late, but I have learned the
> > hard way.
> >
> > FWIW, Lynn W4NL
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
>__________________________________________________
>Do You Yahoo!?
>Tired of spam? Yahoo! Mail has the best spam protection around
>http://mail.yahoo.com
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|