As far as I know, you've always had to dial in -100 to -150 PBT if you
wanted extended low frequency ssb audio response on the Orion.
73, Barry N1EU
On Thu, Feb 24, 2011 at 2:28 PM, John K Gotwals <john@gotwals.com> wrote:
> Yesterday I installed the 565 2.064X11 firmware update followed by the RAM
> Clear and Master resets. In general, things seem to be as expected except
> for the main receive audio. I operate on 75 and 40 meters phone and when
> conditions permit I have my receive bandwidth set at 3000 (Rx Eq = 0dB). I
> immediately noticed that received signals of stations I had worked
> previously are lacking in lows. When I set PBT to -200, the received signal
> sounds normal. Has anyone else noticed this in the new firmware, or is it a
> case where I should do another round of resets?
>
> John, N9JG
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|