TenTec
[Top] [All Lists]

Re: [TenTec] HELP with broken off screw threads

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] HELP with broken off screw threads
From: Mike Bryce <prosolar@sssnet.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 24 Dec 2016 10:15:17 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
berry,

I’ve had that happen before to me, and I’d like to tell you I have a solution.

I tried everything you could think of, including heating the post. No joy. I 
even purchased a ‘speedout’ screw removal bits. No joy that time either and 
ended up mangling the post.

Personally, I’d leave it alone. It certainly isn’t load bearing, and there are 
no shear stress to the pcb, the only thing I could think of would be you’ve 
lost a ground point, although the pcb is ground through wiring and the other 
ground attachments


I feel you’ll do more damage trying to get the screw out than leaving it alone



Mike Bryce, WB8VGE
 the heathkit shop
SunLight energy systems
J e e p
o|||||||o






> On Dec 24, 2016, at 10:02 AM, Barry N1EU <barry.n1eu@gmail.com> wrote:
> 
> The threaded end of an aluminum screw broke off in one of the PCB mounting
> posts in my Omni 6+.  Please have a look here:  http://n1eu.com/screw1.jpg
> 
> I'd very much appreciate advice on how to remove that screw end.
> 
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>