Make sure you're using at least 12v. I had a variable PS and was adjusted for
10v and the rig went crazy.
73,
Ed
--- On Sun, 2/6/11, n5bi@juno.com <n5bi@juno.com> wrote:
From: n5bi@juno.com <n5bi@juno.com>
Subject: [TenTec] Omni VI+ question
To: tentec@contesting.com
Date: Sunday, February 6, 2011, 7:39 PM
My OmniVI+ is having a problem. The frequency readout displays the proper
frequencies for each band selected, but the tuning knob/encoder does not cause
the freq. to change. The RIT/XIT has the same problem. No other noted
problems, rx/tx work just fine. I checked the troubleshooting guide in the
back of the manual to no avail.
If anyone has experienced this problem, please respond here..
73,
de Gary N5BI
____________________________________________________________
Kill Your Wrinkles
Mom Reveals Shocking $5 method for erasing wrinkles...Doctors hate her
http://thirdpartyoffers.juno.com/TGL3131/4d4f69a4947216b46bst05vuc
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|