Hello Barry ,Mark,
For Info.
I had a word with Tentec and the suggestion for two L/S one on the main and
the other on the 2nd RX and to be able to use headphones (although
headphones OR main L/S on the main) is to use a stero splitter plugged into
the Headphone socket on the front ,and feed both L/S from there. Ive tried
it and the audio gain seems to be OK but Im not sure about the matching -as
I dont have a circuit.
I think the new 2nd receiver when it is available will give more audio
gain, and its got a pre amp.... so the RF gain control wont have to be so
high.
Thanks all
Dave G3RXP
----- Original Message -----
From: "Dave G3RXP" <g3rxp@btinternet.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, November 09, 2011 1:55 PM
Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
> Hi Guys,
>
> As soon as you connect headphones to the front socket the loudspeakers
> inside and external speaker is disabled so it doesnt matter how you
> configure the audio controls I cannot get them to all work at the same
> time.
>
> I agree on the RF control, and this is always the way I have run a RX
> whatever the type -but the trouble is that the S meter doesnt work.
>
> Dave
>
>
>
> ----- Original Message -----
> From: "Mark van Wijk" <pa5mw@home.nl>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Cc: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, November 09, 2011 11:09 AM
> Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
>
>
>> One more thing.......
>>
>> Never use any outboard (DSP) processor for the audio. The greatest asset
>> of the ORION is its ability of a wonderfull recovered audio presentation.
>>
>> Use your RF Gain, never set it above 90. Ever. Not even on 10/12mtrs.
>>
>> So, .....actually two :)
>>
>> 73, Mark,PA5MW
>>
>>
>> On 9 nov. 2011, at 11:29, Dave G3RXP <g3rxp@btinternet.com> wrote:
>>
>>> Hi Barry and Mark thanks for the info - I think the internal L/S is
>>> disabled
>>> when the external L/S is plugged in, the same with headphones - but Ill
>>> check those suggestions again.
>>> Just thinking about it I have my headphones connected to the back exp
>>> L/S
>>> via an external DSB audio filter so that may be the problem.
>>>
>>>
>>> Thanks Dave
>>>
>>> ----- Original Message -----
>>> From: "Barry N1EU" <barry.n1eu@gmail.com>
>>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>>> Sent: Wednesday, November 09, 2011 9:28 AM
>>> Subject: Re: [TenTec] Orion 2 query L/S on 2nd receiver.
>>>
>>>
>>>> On Wed, Nov 9, 2011 at 9:18 AM, Dave G3RXP <g3rxp@btinternet.com>
>>>> wrote:
>>>>
>>>>> I would like to monitor the 2nd RX by loudspeaker and use the
>>>>> headphones
>>>>> for the main RX and wondered what is the best method to do this. I
>>>>> could
>>>>> use the line output socket at the back but I may have missed an easy
>>>>> option?
>>>>
>>>> Why not use the EXT SPKR output on the rear panel (or just the Orion's
>>>> internal speaker) with Audio configured as Left/Right=Main and
>>>> Spkr=Sub?
>>>>
>>>> Barry N1EU
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|