It is standard RS232 for a DB9. The female DB9 on the Omni VII pins are
pin 2 TX data ( this is RX data on the PC side)
pin 3 RX data ( this is TX data on the PC side)
pin 5 ground
pin 7 RTS
pin 8 CTS
pin 4 DTR
pin 6 DSR
The Omni VII requires RTS and CTS to be used. It runs only at 57600
baud 8 bit no parity.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 11/20/2014 8:01 AM, Ron Notarius W3WN wrote:
If anyone can help KO7SS, please respond directly to him. Thank you.
-------- Original Message --------
From: ko7ss@yahoo.com
Date: Nov 19, 2014 11:37:54 PM
Subject: Ten Tec OMNI VII question
To: "w3wn@n3sh.org"
Hi,
I can't seem to join the Ten Tec reflector to ask a question, maybe you can
post it? This info is not in the manual....
I am trying to connect an OMNI VII serial port to an Expert Amps 2K-FA.
Which of the pins on the OMNI VII serial port is the TX 232?
Thanks, Bill Straw, KO7SS
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|