On 7/27/2013 7:15 PM, Bob McGraw - K4TAX wrote:
Now if the inductance is maximum value then
it is very apparent where Z should be located, either on the input of L
or the output of L. I believe it general practice to start with maximum
inductance for adjustment of any L network.
_____________________________________________
Hmmm... so it appears the instruction manual
does not describe the best approach? I understood
the user manual to say I should start with zero
on the Inductor, and the Capacitor at around 2.
In contrast, based on your description, it appears
I would be better off starting with the inductor in
the middle - away from either end - and that starting
there will make it more obvious what initial capacitor
setting to select on the BYPASS switch. I know that
is not "maximum" - but it would assure that I started
working against a substantial inductance, rather
than zero.
Or... have I misunderstood?
---------- Thanks - K8JHR -----------------------
--.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|