| To: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] Cleaning band switches Triton IV Digital |
| From: | Richards <jruing@ameritech.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 15 Feb 2012 20:34:33 -0500 |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
If it wiggles... can you adjust the tension on the axle/shaft ? ====================== K8JHR ================ _________________________________________________ > > On 2/15/2012 6:56 PM, Rich Jones wrote: > > wiggling the band knob helps correct this problem. > > obvious to me, dirty switch wafers. > >> _______________________________________________ ---/. _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Cleaning band switches Triton IV Digital, Richards |
|---|---|
| Next by Date: | [TenTec] Low (to no) Power Out Omni D--han'nt given up yet, scottsheppard |
| Previous by Thread: | Re: [TenTec] Cleaning band switches Triton IV Digital, Richards |
| Next by Thread: | [TenTec] Wanted: 300hz Filter (Orion II, Eagle), Barry N1EU |
| Indexes: | [Date] [Thread] [Top] [All Lists] |