To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
---|---|
Subject: | Re: [TenTec] 160 Meter Problem |
From: | "Bob McGraw - K4TAX" <RMcGraw@Blomand.net> |
Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
Date: | Mon, 18 Aug 2014 10:40:42 -0500 |
List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
Probably an issue with the LowPass Filter board for 160M related to K12 and
or K13 that switch the components for 160M filter. Likely one or both relay
coils are open. Since they are actually parallel. It is easier to replace
them than pull both out just to check them.
73 Bob, K4TAX----- Original Message ----- From: "Jim Allen" <jim.allen@longhornband.net> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com> Sent: Monday, August 18, 2014 9:11 AM Subject: [TenTec] 160 Meter Problem I was sitting in the shack minding my own business last night when I noticed on the DX cluster that W1AW/5 was on 1821.5 in Oklahoma. I have not tried 160M here, but do have a 130' dipole and an AH-4 to match it with, which might work, so I thought, "what the hey?"I got it all set up and could hear W1AW/5 extraordinarily well. I moved upthe band a bit to tune and ........ nothing. No output whatsoever. I checked... traced the coax, antenna connected to wattmeter, wattmeterconnected to Omni VI+, AH-4 tune control getting power, etc. All seemed to be in order. I tried again... nothing. The radio went into tune no outputno tone, nothing. I switched to 80M, found a clear spot, tuned normally.I went back to 160M, nothing. I advanced the power knob from nothing to ashigh as I dared... still nothing. I then moved to the 706MKIIG, got it going on 160 and made the contact, no problem, although I did have to use 100 watts instead of 5. This is the first time I have tried this Omni VI+ on 160M, but it seems to be working just fine on the other bands, very well, actually. What could this be? Where should I start? 73 de W6OGC Jim Allen _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TenTec] 160 Meter Problem, Rick - DJ0IP / NJ0IP |
---|---|
Next by Date: | Re: [TenTec] 160 Meter Problem, Jim Allen |
Previous by Thread: | Re: [TenTec] 160 Meter Problem, Mike Bryce |
Next by Thread: | Re: [TenTec] 160 Meter Problem, Jim Allen |
Indexes: | [Date] [Thread] [Top] [All Lists] |