Steve,
I think I've done 4 re-builds now. On each one I've needed to carefully
select the number of washers which space off the plastic spring housing
at the back of the PTO; they determine how much pressure is applied to
the shaft assembly : too few washers and it all feels very stiff, too
many and the vernier slips. I don't always get it right first time -
what "feels right" when the PTO is out of the radio never seems quite
the same when it's back in the radio and been used for a bit! In one
case I used combinations of TT's washers and some thinner ones to get it
just how I wanted.
I keep meaning to see if I can make that spacing "screwdriver adjustable".
It's not an easy adjustment to make with the PTO in the radio ..... and
of course this may not be your problem anyway :)
73,
Steve G3TXQ
On 06/09/2011 03:05, Steve Berg wrote:
> I had the factory rebuild both PTOs in my Corsair II and the external
> VFO last year. The one in the rig has settled down, but the one in the
> external VFO is acting up. It is still stiff, and has a lot of slop
> when trying to tune it slowly. I noticed this weekend, that the dial
> skirt moves at the same rate as the tuning knob. So, apparently there
> is minimal vernier reduction going on. Before I send it back, is there
> a fix for this that I can do myself without disassembling the PTO itself?
>
> Thanks!
>
> Steve WA9JML
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|