Here's what I did:
I made a pencil rubbing of the buttons on the rig to get the exact size. Then I created a rounded rectangle in a Word document, sized it
correctly, and colored the fill and outline with the penultimate darkest shade of brown in the standard palette. Then I copied it eleven
times, so I had the twelve required. (Don't make them too close together; they are harder to cut out if they are closer than about half
the label's width apart.) I formatted them as behind text, and produced the text I wanted on the buttons. Instead of having a 1 over the
160 key, I made the labels "160/1", "80/2", etc., through "ENTER", "SHIFT/0", and
"CLEAR". I made the text in Ariel 10 point, white in color. You can make fine adjustments in the position of a shape by
selecting it and then "nudging" it with the arrow keys. This centers the text on each label.
I copied the set of twelve and pasted them back in twice, so I would have two
extra sets, in case I messed up, which I did. I printed the page on an Avery
5165 8 1/2 by 11 label. Here's the trick, which took some experimentation to
discover: Put a piece of Scotch tape (the shiny kind, not the transparent,
invisible kind) over the rows of labels before you cut them out. This protects
the corners when you are cutting them out, and protects the printing from your
finger when you use the buttons. It also makes them look nicer than the flat
paper stock.
I removed the old labels, cleaning off the glue with rubbing alcohol, cut the
new labels out with an Exacto knife, and stuck them on. It took a couple of
tries in a few cases, especially because I have a tremor that makes fine motor
control difficult. But it worked. My wife came in to see the results (she had
seen me working on the computer), and couldn't find the labels until I pointed
them out to her.
I can email you the Word file if you want.
Good luck.
73,
Frank
KF6E
-----Original Message-----
From: Tim<wa5yom@arrl.net>
To: Discussion of Ten-Tec Equipment<tentec@contesting.com>
Sent: Mon, Nov 22, 2010 10:57 pm
Subject: Re: [TenTec] Omni V chips
On 11/22/2010 9:59 AM, kf6e@mail.com wrote:
I asked that a while back, but got no leads. I suspect we're on our own.
73,
Frank
KF6E
-----Original Message-----
From: Tim<wa5yom@arrl.net>
To: tentec@contesting.com
Sent: Sun, Nov 21, 2010 9:51 pm
Subject: [TenTec] Omni V chips
Does anyone have access to the stickers to put over the keys...for the
N4PY Omni V.9 chip?
Thanks,
Tim, WA5YOM
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
I will post what-ever solution I come up with.....
Thanks,
Tim, WA5YOM...
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec