Hi John and group. I imagine John that you are aware of the little marker
that rides along the top of the sweep screen as you tune. Since the sweep
stops during tuning, I can see how that would work pretty well to find a signal
or a quite spot but you have to be tuning to get there. May not work so well
on traffic handling when you want to send someone up or down so many
Khz. Hmmmm..............?
Ten Tec did not fix my complaints which involve audio levels which are all
goofy compared to 1.373. I have to have sidetone on 5 to balance with the
incoming audio. Out of a range of 1 to 100, that yields very coarse setting.
Then, the spot level is way too high. Turn down the spot level (using
sidetone control) and of course the sidetone is too low to be useful. What a
bummer. I would think TT could handle that little detail easily. I also
have
pretty low output level on the aux audio output. Hardly enough to drive my
sound card.
Well, I'll give it some time but it looks like I'll be going back to 1.373b5.
That
one is still the best I've found for my purposes. At least I have some
options..........that's nice. :-)
73,
-Lee-
WA3FIY
On 14 May 2009 at 16:52, John T. Fleming wrote:
> I installed the new software and my one complaint has been repaired. If the
> sub-receiver is on AM and the transceiver is operating in the SSB mode, once
> the rig transmitted, the headphone audio disappeared. That is now fixed.
>
>
>
> The small marks at the bottom of the sweep are missing which to me and
> traffic handling, it is going to take some adjustment to guess where there
> is a quiet spot for passing traffic.
>
>
>
> Thanks Ten-Tec for your work.
>
>
>
> 73,
>
> John
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|