Re: [TenTec] OmniVI rotary encoder

[Steve Hunt <steve@karinya.net>]

Bob,

Thanks - the new part should be with me by the weekend, so I'll give it 
a go then.
Steve G3TXQ

On 08/08/2018 14:28, Bob McGraw K4TAX wrote:
> Once you have the top and bottom covers off, remove the top screw on 
> each side of the front panel.  The front panel will tilt forward for 
> access to the encoder.
> 73
>
> Bob, K4TAX
>
>
>
> On 8/8/2018 4:14 AM, Steve Hunt wrote:
> > Folks,
> >
> > I need to replace the rotary encoder in my OmniVI. Can anyone tell me 
> > the easiest way to get at it and do the replacement. It's easy to 
> > spot the encoder when you take the bottom cover off, but I wonder it 
> > you then need to fully remove the front panel, and if so how big a 
> > job it is?
> > Steve G3TXQ
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec