TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI tracking

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VI tracking
From: Ken Brown <ken.d.brown@hawaiiantel.net>
Reply-to: ken.d.brown@hawaiiantel.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 13 Jan 2007 17:48:32 -1000
List-post: <mailto:tentec@contesting.com>
Hi Art,

If you are talking about in SSB mode, in theory it cannot be wrong, 
because all of the oscillators in use for TX are the same and have the 
same logical commands applied to them when in RX mode. On the other 
hand, when in CW mode the BFO is switched between 9.000000 MHz for 
receive (same as LSB receive BFO Frequency) and 9.000400 MHz for 
transmit, and the VFO gets different numbers loaded into it, depending 
on the sidetone setting you have selected. The most likely cause of a 
discrepancy between TX and RX frequency would be misalignment of the 
trimmers in the BFO, which is on the TX AUDIO BOARD.

N6KB


Art Lewis wrote:
> I have an Omni VI that works real well, but seems not to be tracking the 
> exmit and rec frequency correctly with my RIT off. I seem to have about a 
> fifty Hz difference. I am using the RIT to correct the problem, but I wonder 
> if there is a simple adjustment I can make. 
>
>                    Art WA8VSJ
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>   

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>