My Paragons don't go down that low. I wanted to try to listen to SAQ on
17.2 kHz and found that my Paragon II only goes down to 99.9 kHz. When
KPH was on the air last week, I used the Paragon II to hear them on all
their HF frequencies. I was also able to hear them on 426 kHz with the
Paragon II, but I was not too impressed with the performance. Using my
160 meter (1/4 wavelength) inverted L, I expected the 426 kHz signal to
be much stronger that it was. I suspect the Paragon's sensitivity at 426
kHz is not too hot, and it is probably no better at 100 kHz.
How do you make yours work at 7.51 kHz?
DE N6KB
Robert & Linda McGraw K4TAX wrote:
My Paragon and my Paragon II both will transmit and receive on that
frequency. Of course since the US ham band is 7.0 to 7.3 MHz I dare not try
it except on a dummy load. -:)
73
Bob, K4TAX
----- Original Message -----
From: "Ken Brown" <ken.d.brown@verizon.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, July 17, 2005 5:45 PM
Subject: Re: [TenTec] Ten Tec Net
There is also the TT SDR (Software Defined Radios) on 7.51 Khz at 6 PM
Eastern.
Wow! The 40 km band. What TT rigs work there?
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|