Also you can press the A=B, hold and it will display the version as long as
you hold the button.
Rog
----- Original Message -----
From: "Richards" <jruing@ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, October 26, 2010 12:20 AM
Subject: Re: [TenTec] OMNI VII Firmware version
> Press and hold the MNU button as you turn the rig on.
> Read the screen info quickly and then turn the rig off.
>
> That should tell you the version info, without doing
> any changes to the setup. The info will stay on screen
> for "while" - maybe until you turn the rig off (although
> it may time out... I have not left mine on all that
> long to know...)
>
> Just MY take.
>
> ============================= James -K8JHR ===============
>
> On 10/25/2010 11:58 PM, Phil Coley wrote:
>> Just picked up a nice pre-owned OMNI VII. How does one check the current
>> version of firmware installed on unit?
>>
>> I've checked the manual and website and don't see any reference as to
>> "how". Help would be appreciated.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|