TenTec
[Top] [All Lists]

[TenTec] trouble interfacing OMNI VI to N1MM via serial port

To: "tentec@contesting.com" <tentec@contesting.com>
Subject: [TenTec] trouble interfacing OMNI VI to N1MM via serial port
From: Joseph Holstein <n8ea@prodigy.net>
Reply-to: Joseph Holstein <n8ea@prodigy.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 17 Nov 2011 09:36:14 -0800 (PST)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
followed instructions in the TenTec manual and have pins 2 and 3 and 7 on the 
DB 25 going to the DB 9 . DB 9 has pins 4 and 6 shorted. Followed directions in 
N1MM for Omni VI - 1200 baud etc.  Pin 5 on DB9 connects to pin 7 on the DB25.  
Any suggestions ?
73 joe n8ea
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>