TenTec
[Top] [All Lists]

[TenTec] [Fwd: Ten Tec archives]

To: tentec@contesting.com
Subject: [TenTec] [Fwd: Ten Tec archives]
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
Reply-to: geraldj@storm.weather.net, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 11 Jun 2009 11:09:07 -0600
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
-------- Forwarded Message --------
> From: snowy.howell@openreach.co.uk
> To: geraldj@storm.weather.net
> Cc: snowy.howell@btinternet.com
> Subject: Ten Tec archives
> Date: Thu, 11 Jun 2009 11:47:28 +0100
> 
> 
> Good morning Doc from the UK.
> 
> I have a request for help/advice that I would like to post onto the
> Ten Tec archives but cant seem to post it.
> 
> If tell you my tale of woe can you be so kind as to post it for me or
> advise how I can do it for myself.
> 
> I have a Corsair 1 that now has some erroneous frequency readings on
> 10, 17, 21.
> 
> When I purchased it there were no readings at all (all 'E's), the
> circuit diagram and component layout pictures in the manual are
> different to what is fitted to the radio.
> 
>    
> I purchased at great expense the 'prom' for the counter display, that
> made no difference.
> 
> I then replaced all of the 'ic,s' in the counter and it started
> working on some bands.
> 
> I subsequently found out from the seller that he had changed all the
> diodes on the counter board, on checking the circuit diagram some of
> the diodes look to be the wrong way round, maybe this is what is
> causing the erroneous readings!!

I have only Corsair II data and there are no diodes on the counter
board, but a gang of diodes could have been used in the Corsair to
convert band data to binary for the processor. Diodes backwards will
upset that logic.
> 
> My question is 'Has anybody got a digital picture or can take one of
> the diodes so I can compare their picture to my PCB'.
> 
> Is the frequency display the same as the Corsair 2, I have 1 of those
> radios as well that I can refer to.  

Apparently not since there are no diodes on the 2's counter board. There
is a single wire band input but I've not been able to trace it. Probably
the BFO, and injection frequency inputs are enough to count the band
correctly.
> 
> If you please pick out the relevant points and post that for me
> please.
> 
> Regards
> 
> 73
> 
> G0HZE  
> 
> Snowy Howell  BCRE25
> 
> BT OPENREACH 
> 
>  
> 
> Tel  (01733) 816251
>  Fax (01733) 331886
>  E mail snowy.howell@openreach.co.uk
> 
73, Jerry, K0CQ

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>