On Mon, 2008-03-24 at 12:55 -0600, Paul DeWitte K9OT wrote:
> First, I know that you can use the offset to fine tune a station. But I am
> wondering if anyone has installed a reduction on the VFO to slow down the
> tuning rate on the Omni/Corsair series radios.
>
> If so what did you use and what kind of reduction ratio was it?
>
> Thanks 73
> Paul K9OT
There is already a reduction built in, but if the knob and the bezel
move at the same speed that reduction is frozen stiff. Then it needs a
rebuild.
On my Corsair II, I made a new larger knob, about 2" diameter solid
aluminum that gives a little bit more effective reduction from the
sliding finger and with its weight gives a better feel for tuning. In
either case its so much better than the BC-348 that I get along just
fine.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|