I soldered bare wires that were the same diameter as the pins on the new OII
filters to the 352 filter. I then carefully bent these wires so they
matched up with the holes on the OII filter board. This is working
perfectly on my OII.
Carl Moreschi N4PY
Franklinton, NC
----- Original Message -----
From: "Bill Tippett" <btippett@alum.mit.edu>
To: <tentec@contesting.com>
Sent: Monday, January 02, 2006 12:45 PM
Subject: [TenTec] Filter for SAle
> W9OY:
>
> >What is the new center freq of the Orion II filters?
>
> 9.001500 MHz (same as first bank in original Orion)
>
> >I read someone rewired his INRAD 600hz filter in such
> a way that it would work with the O2. If this is the
> case, is it possible to trick out the new O2 filters
> to fit in one of the old 1st filter slots?
>
> N4PY modified the pins in the base of his
> 352(762) and it apparently works fine. Ten-Tec
> used a different filter vendor for O2 filters
> which have a different base configuration.
>
> 73, Bill W4ZV
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|