I can't "certify" it as correct
I got mine 2nd hand and po had been in there trying to fix a broken
wire but that is how the segment of cord left attached to plug was and
I made sure inside matched to that.
As you mentioned---zip for documentation on the wiring of it
Paul K0UYA
-----Original Message----- From: Stan Gammons
Sent: Saturday, July 28, 2018 5:02 PM
To: tentec@contesting.com
Subject: Re: [TenTec] 707 microphone
Hi Paul!
Thanks!
73
Stan
KM4HQE
On 07/28/2018 04:30 PM, Paul Kraemer wrote:
1= mic low
2= mic hi
3= ptt
4=common
Shield to shell
That is what works on mine anyway
Paul K0UYA
-----Original Message----- From: Dry Martini Holding Company😎
Sent: Saturday, July 28, 2018 4:11 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] 707 microphone
If no one answers you, I will give it to you when I get home. I am on
my way out to eat.
Robert
KG4KGL
On Jul 28, 2018, at 15:16, Stan Gammons <s_gammons@charter.net> wrote:
Hi All,
Does anyone know the pinout for the 4 pin XLR connector on the
TenTec 707 mic? I couldn't find any documentation for the mic on
the TenTec site.
Thanks
73
Stan
KM4HQE
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec