The QSK loops are just signal cables and do not carry RF. The simple radio
shack shielded audio cables with RCA phono connectors on each end work fine.
I have been using them for years. I assume you are talking about the cables
that go to TXEN and TXOUT.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "Allan Taylor" <k7gt.cw@gmail.com>
To: <tentec@contesting.com>
Sent: Friday, August 15, 2008 9:42 AM
Subject: [TenTec] cabling question re TT 253 tuner
>A question for 253 tuner users. I recently acquired two (2) 253 tuners
> to assist in automating my station. The
> instructions say to use interconnecting cables of RG174 for the QSK
> loop. These cables will need to have RCA phono
> plugs on them. Is there an obvious source of high quality (read that
> well-shielded) cables with phono plugs? Will R/S
> cables do? Would it be necessary to use UHF to RCA phono adapters and
> RG58 equivalent? One of the tuners came with
> two such adapters...
>
> The setup is with an OmniVI and Hercules II amp. I will be doing the
> same on occasion but with a Titan instead of the
> Herc II.
>
> --
> 73 Allan K7GT
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|