Tom,
Not sure about the QS1R SDR, but it should work fine with the SDR-IQ from
RFspace. Keep in mind that you will probably want to put a Z10000B-U buffer
amplifier from Clifton Labs (with 0 dB gain) between the RX366 and the
SDR-IQ or QS1R (not sure about the required gain for a QS1R, check with Jack
Smith K8ZOA at Clifton Labs). The Z10000B-U is reasonably priced (even
assembled tested and installed in a box).
Stephen AD7TD
-----Original Message-----
From:
On the RX366 board there will be a 9MHz output via TMP connector. Does
anybody know if that means I can connect the output from the 9MHZ IF to my
QS1R SDR receiver directly and see the waterfall display?
Thanks Tom AA4VV
On 12/1/2011 11:10 AM, John Henry wrote:
> Something that I think some customers are not aware of, or have
> missed, since this is built using the TXRX board of the Eagle, this
> means that there is a 9MHz output available on a TMP connector. This
> can be brought out to provide a second sweep on a PC, in addition to
> the Main RX 9MHz IF output.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|