Mine has the FW Bridge mounted on the bottom of the chassis with wires going
to it.
73
Bob, K4TAX
----- Original Message -----
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Tuesday, January 01, 2008 8:28 PM
Subject: Re: [TenTec] 962 Power supply Bridge rectifier needed
> On Tue, 2008-01-01 at 20:20 -0600, Bob McGraw - K4TAX wrote:
>> How about this: GBPC3501 $2.92 in single lot qty. From Mouser
>>
>> Manufacturer data sheet: http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf
>>
>> 35amp, 100 PRV. It is a real generic non-critical part. Now what's
>> critical is to clean the bottom of the power supply where the bridge
>> block
>> mounts, make sure you have some good heat sink compound but not too much
>> and
>> bolt the sucker in tight with the center mounting screw. If you
>> choose,
>> use the crimp on spade lugs but do solder the wires to the female spade
>> terminals. When pushing the lugs on, make sure they are tight and snug.
>> Otherwise if you have a suitable soldering iron, solder the wires direct
>> to
>> the bridge block.
>>
>> 73
>> Bob, K4TAX
>>
> Now he says it plugs into the PC board and the NTE lugs don't line up
> with the slots in the board. In the NTE catalog I see two post
> arrangements and one with round wires. I can't tell from here which
> fits.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|