Thanks Barry and all the rest of the folks who offered suggestions.. as
these things often go, it was more operator error than anything else... I
had somewhat of a kluge setup between the Argo V and Orion.. I made a new
cable and the vox worked fine...
Thanks to all... I'm still using my Signal Link, but I feel better knowing
that the Orion is working right.. :)
73
Tim
NZ8J
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, November 06, 2005 9:24 AM
Subject: Re: [TenTec] Orion Aux Input (Vox)
> Yup, y'all were right and I did get vox to work on Aux audio but I had to
> set the Aux Input Gain much higher than I normally do with PTT.
>
> Tim, you should try cranking up the Aux gain and see if vox kicks in.
>
> FWIW, I'm driving Aux input with pro line level 0dB
>
> 73,
> Barry N1EU
>
>
> On 11/6/05, N0KHQ@aol.com <N0KHQ@aol.com> wrote:
> >
> > The Orion Aux Input supports Vox.
> >
> > Keep in mind that the audio must be delivered at line level voltages
> > (millivolts).
> > The Aux Input will not produce an output if driven at mic level voltages
> > (microvolts)
> >
> > I always use the Aux input on my Orion for an audio input and my Vox
works
> > just fine.
> >
> > Running Orion ver. 1.372 Barry.
> >
> > John / N0KHQ / St. Louis
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|