Steppir makes a Y connector. This allows both your computer and steppir to
be connected to the Orion at the same time. This works because in this
setup, steppir only listens on the comport and does not send.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "George" <goofyham@highstream.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, August 16, 2006 4:16 PM
Subject: [TenTec] ORION_RS232
> I am using the Orion2 RS232 with my SteppIR controller. How can I use
multiple RS232 sources with only one Orion RS232 connection on it's rear?
> I'd like to use the SteppIR controller and my computer to connect to the
Orion. Each has a RS232 output.
> Any ideas?
> Thanks
> George
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|