It'll be at 2.4kc in a few minutes. My new years' treat to you!
73 =p= w8kc
----- Original Message -----
From: "Paul Christensen, Esq." <w9ac@arrl.net>
To: <tentec@contesting.com>
Sent: Tuesday, December 30, 2003 8:19 PM
Subject: Re: [TenTec] Holiday Stream - 7.040 MHz
> Hi Paul,
>
> Your stream has been working very well and with the time delay between
> transmit and receive its been fantastic is hearing what my signal sounds
> like in the distance for the first time!
>
> Any chance you can open up the RX bandwidth to 2.4K from 1.8K for a day or
> so? I would like to hear just a bit more detail on my sig. Thanks!
>
> -Paul, W9AC
>
> ----- Original Message -----
> From: "Paul Valko" <prvalko@comcast.net>
> To: "Low Power Amateur Radio Discussion" <qrp-l@Lehigh.EDU>
> Cc: <tentec@contesting.com>
> Sent: Wednesday, December 24, 2003 2:36 PM
> Subject: [TenTec] Holiday Stream - 7.040 MHz
>
>
> Seasoned Greetings to all my friends on QRP-L and the Ten*Tec Reflector!
>
> As a holiday treat, I will continue to stream the soothing sounds of one
of
> our favorites, the ever-popular 7.040MHz QRP calling frequency.
>
> Take a moment for yourself this holiday and tune in, won't you?
> http://www.w8kc.com/stream.asx
>
> Give it a listen if you get the chance. eSWL reports appreciated.
>
> It's my Corsair with the 1.8kc filter in line. Antenna is a full wave
> dipole with ladder line through an LDG AT-11. My QTH is about 30 miles
due
> north of downtown Detroit.
>
> 73! =paul= W8KC
> Collector of Ten*Tecs and other fine plastics.
> Visit the Virtual Ten*Tec Museum at http://mywebpages.comcast.net/w8kc
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|