Re: [TenTec] Need 962 P/S info

["Steve N4LQ" <n4lq@iglou.com>]

Yes and if you are going to use it to power another rig you need to somehow 
short together the 2 white wires otherwise the ps will not turn on. 
So....Red=+ Black=-, white wires go to on-off switch in rig.
Steve N4LQ
----- Original Message ----- 
From: <Able2fly@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, January 18, 2005 7:26 PM
Subject: Re: [TenTec] Need 962 P/S info


> Todd,
>
> > From the TT "manual":
>
> "Any high current connections should be made at the 4  pin connector at 
> the
> end of the output cable. Pin 1 (black wire) is the chassis  ground and 
> high
> current return. It is identified by a rib on the plastic shell  of the 
> connector.
> Pins 2 and 3 (white wires) are connected in series with the  front panel
> POWER switch and Cary the "hot" side of the 115/230 VAC line. These  two 
> lines
> facilitate remote ON/OFF switching of the power supply. Pin 4 (red  wire) 
> is the
> =13.5 VDC output."
>
>
> ======================
> Hello all, I recently purchased a 962 P/S and no longer have my Omni 6+
> manual as I sold the rig. I need to know which wires are +/- on the DC 
> power
> cable.
> There's white, green, red & black. I'm hooking up my Brand K rig  to this 
> P/S
> & need to know the right connections.( I can assume white /  red is hot,
> black
> / green is ground, but we all know the definition of  assume, Hi Hi.) I 
> would
> just like to be sure. Thanks for any help.
>
>
> 73, Todd - KT0DD - kd7efq@aol.com
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec