Many Thanks Dave
Next time the problem will be on i will try your method.
I will say something at next step...
73 HNY de IK1QHB
----- Original Message -----
From: <OTAKEBI@aol.com>
To: <tentec@contesting.com>
Sent: Sunday, January 06, 2008 12:21 AM
Subject: Re: [TenTec] fix OMNI V
>
> You say that when you open the case the problems goes away.
> Check to see if one of the eight screws that holt the case on is touching
> a
> wire.
> The tightening of the screws seem to be causing the problem by touching
> something or slightly bending a board causing something to touch that
> should not.
> I would put the case back on and cause the problem to show up.
> I would remove one screw at a time.
> If the problem goes away with the removal of a certain screw look for the
> problem near that screw.
> I would remove all the screws on one side (first from the top cover then
> from the bottom cover).
> If the problem does not go away on the side do the other side.
> The rig needs to be on when you do this and any other detective work.
> I once fixed a rig that had the same problem.
> Two other technicians kept looking at component problems.
> The top cover, when made tight caused a board to bend and a trace on the
> board would open and the radio would malfunction.
> I would look for that or a board touching to ground or one of the screws
> touching something to ground.
> The rig will work fine once you find it.
> Good luck,
> Dan/N4VET
>
>
>
>
> **************Start the year off right. Easy ways to stay in shape.
> http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|