TenTec
[Top] [All Lists]

Re: [TenTec] 263 Remote VFO PTO

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 263 Remote VFO PTO
From: "Steve N4LQ" <n4lq@iglou.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sat, 26 Feb 2005 10:03:59 -0500
List-post: <mailto:tentec@contesting.com>
Wish I knew the exact size wrench but yes on most TT gear you must remove 
all knobs and front panel to access the screws holding the PTO on the frame.
Steve Ellington
N4LQ@iglou.com
----- Original Message ----- 
From: "Howell, D. Haney" <howellh@winthrop.edu>
To: <tentec@contesting.com>
Sent: Saturday, February 26, 2005 9:40 AM
Subject: [TenTec] 263 Remote VFO PTO


>I have in hand the rebuild kit for the PTO in my remote VFO for the Omni D. 
>That's the good news.  The bad is that I can't get the main tuning knob off 
>the front.  I've tried every allen wrench and bristol I can find and 
>nothing seems to fit.
>
> Also, must you dismantle the entire front panel to release the PTO box?
>
> The TT instructions start with "remove the box from the radio".
>
> Thanks
>
> Haney
> K2XN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>