The Model 318 has 2x 8-pin DIN jacks wired in parallel.
This enables you to connect the device itself to the Eagle, and still have
another 8-pin Jack available for any accessory you like.
It has a separate RCA Phono Jack for Amp Key (out to amp).
It also has yet another RCA Phono Jack connected to the PTT line, enabling
the use of a foot switch, straight key, keying signal from a computer,
whatever.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Bob McGraw
- K4TAX
Sent: Sunday, September 21, 2014 1:43 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] din connector, news from Hall Mountain KY
Seem to recall that Tentec has a "Y" type connector that will allow one to
use two devices such as a soundcard and amp keying line.
Also, seem to recall the amp keying accessory {318} has a 2nd DIN that
allows for amp keying delay plus a second accessory.
Might check with Paul in Service on this.
73
Bob, K4TAX
----- Original Message -----
From: "John" <k4avx1@windstream.net>
To: <tentec@contesting.com>
Sent: Saturday, September 20, 2014 11:21 AM
Subject: Re: [TenTec] din connector, news from Hall Mountain KY
> Thanks to everyone for the info on the Din (not mini-DIN) connector on
> my Eagle. I guess it's symptomatic that I would think the connector is
> smaller, since I'm older since I put one on!!
>
> I took early advice, went on E-Bay and found the amp line custom built.
> But I already have those pins connected on a crooked connector using
> one of Mike's amp keyers, which incidentally, works like a charm. Hope
> he can make them available again...
>
> On eBay, I found a male two ended 8 pin DIN cable at a reasonable price.
> It's on its way, and I can redo the amp circuit and make use of the
> other pins as needed, IF it has full wiring for all pins.
>
> In other news, death to my Omni 6+, as it just came back from the factory
> un-fixable. Brain dead. Can use the filters in the Corsair II, that I
> put the
> DDS Vfo into. It was a great rig.
>
> Learning more about the Eagle and I like it very much. Worked two new
> DX countries last night, and plan to work the S.C. party today, perhaps
> the Scandinavian Contest if bands are decent.
>
> Thanks again for all the help,
>
> 73, John, K4AVX
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|