I have to set the Orion audio gain very low. I have it at 10% in order not
to overdrive it on transmit. The monitor output is just a little low.
Carl Moreschi N4PY
Franklinton, North Carolina
n4py@earthlink.net
----- Original Message -----
From: "Dave Heil" <k8mn@earthlink.net>
To: <tentec@contesting.com>
Sent: Sunday, May 18, 2003 8:56 AM
Subject: Re: [TenTec] Orion Software v1.341
> Carl Moreschi wrote:
> >
> > I find on my Orion that I have to put the monitor audio at 100 just to
get
> > adequate audio. I don't have any extra.
>
> Are you using a Heil microphone element or some other mike with lower
> output? Does the RF output you see seem a bit stingy? There is a
> microphone gain compensation pot located on the bottom panel just behind
> the "MIC/PH/CW" jacks. It is accessible through a hole in the panel.
> You might find that increasing the gain setting cures both the stingy
> output and monitor level problems.
>
> Dave Heil K8MN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
|